M C Q s D r i v e
03079682698
mcqsdrive@gmail.com
About
Contact
Jobs
Blog

Contact Info

03079682698

mcqsdrive@gmail.com

Ad Banner

Medical Science Mcqs 5254 MCQs [All-Courses]

thumb

Medical Science is the study of human health, diseases, prevention, and treatment, focusing on diagnosis, patient care, and medical research to improve healthcare outcomes.

All Topics  5254

The point at which a stress of a material exhibits a specific limited deviation P is called_______________?

A Proportional limit
B Tensile strength
C Ultimate strength
D Yield strength
Correct Answer: Yield strength

Compressive stress is computed by dividing the external force by the_______________?

A Area of the test specimen upon which the weight rests
B Elasticity of the test specimen in strain
C Length of the test specimen beneath the force
D Strain of the test specimen per unit length
Correct Answer: Area of the test specimen upon which the weight rests

The proportional limit is defined as______________?

A The maximum stress in a structure
B The minimum force required to cause a structure to break
C The maximum stress that can be induced without permanent deformation
D The maximum elongation under tension that can be measured before failure
Correct Answer: The maximum stress that can be induced without permanent deformation

Stress in defined as_______________?

A An applied load or force
B A deformation resulting from an applied load
C An external force opposing an applied load
D An internal force opposing an applied load
Correct Answer: An internal force opposing an applied load

Setting expansion is advantageous in__________________?

A Casts
B Models
C Investment
D Dies
Correct Answer: Investment

Back pressure porosity can be avoided by________________?

A Using asbestos linear
B Placing the sprue at least one quarter inch away form the end of casting ring
C Preventing rapid heating the investment in burnout oven
D Using a short and wide sprue
Correct Answer: Placing the sprue at least one quarter inch away form the end of casting ring

Which of the following zones is used for melting alloy during casting______________?

A Reducing flame
B Oxidizing flame
C Green flame
D All of the above
Correct Answer: Reducing flame

Cleaning of base metal alloy is done by______________?

A Warm HCI
B Cold HF
C Cold H2SO4
D Sand blasting with aluminium oxide
Correct Answer: Sand blasting with aluminium oxide

Which one of the following is most elastic ?

A a titanium
B B titanium
C Chrome-cobalt-nickel
D Nickel-titanium
Correct Answer: Nickel-titanium

A thinner mix of a gypsum bonded investment will_______________?

A Produce a smoother casting
B Decrease setting expansion
C Increase setting expansion
D Increase thermal expansion
Correct Answer: Decrease setting expansion
03079682698
mcqsdrive@gmail.com

Copyright @ 2026 MCQsDrive . All Rights Reserved.